Ricoh fax4700l Operator's Manual page 839

TROUBLESHOOTING
Contents
GETTING AQUAINTED IC FAX Com
WITH NIC FAX Redirector
GETTING READY TROUBLESHOOTING
INTERNET FAXING APPENDIX
USING FUNCTIONS
GLOSSARY
Index
IC FAX Monitor
Message
[Administrator Mode
Monitor Error]
No input for 10 minutes
so returning to User
mode.
Address is too long.
[Application Error]
Stopped due to an
error when retrieving
Address Book data.
[FAX command error]
Sorry, not executable at
the moment.
[Application Error]
System error.
[Application Error]
System timer reset
failure.
[Network Error]
Failed to initialize the
status.
[ FAX command error]
Timeout occurred.
170
Causes and Recommended Actions
• IC FAX Monitor is automatically returning to the
User Mode after being left in the Administrator
Mode for 10 minutes without any input. Re-enter
the Administrator Mode if you need to make
more settings. (Page 122)
• The specified address is too long and cannot be
stored. Up to 254 characters, including dial
options, can be input for a fax number.
• A network error occurred while getting data from
the NIC FAX address table. Check the following
points, reconnect, and try again.
• Confirm that NIC FAX is turned on.
• Confirm that the LAN cable is correctly con-
nected to NIC FAX. (Page 24)
• Check whether NIC FAX network settings have
been changed. (Page 56)
• Maintenance procedure is being performed by
service personnel. Wait until maintenance is
finished.
• Problem with the Windows system. Restart your
computer.
• Problem with the Windows system. Restart your
computer.
• A network error occurred while getting NIC FAX
status data. Check the following points, recon-
nect, and try again.
• Confirm that the LAN cable is correctly con-
nected to NIC FAX. (Page 24)
• Check whether NIC FAX network settings have
been changed. (Page 56)
• NIC FAX is busy. Wait a while and try again.