Ricoh fax4700l Operator's Manual page 458

ADVANCED FEATURES
3. Set one of the two as shown opposite
Press 6 of the ten key pad to change the
setting of digit 6.
Press 7 to change the setting of digit 7.
4. Finish: Yes and Function.
Switching Forwarding On/Off
Before you use Forwarding, you have to switch it on using Function 62. If it is
switched off, the machine will not forward any incoming fax messages.
After you switch Forwading on, <FORWARD> is displayed on the operation panel
when the machine is in standby mode.
Note: Forwarding cannot be switched on if Memory Lock is switched on. If you
wish to use Forwarding, you must switch Memory Lock off.
1. Function 6 0 2 2 2 2 6 and 2.
2. Scroll through the list of features with
and until "FORWARDING" appears.
3. Change the on/off setting by pressing
4. Finish: Yes and Function.
Enabling and Disabling the Forwarding Mark
The forwarding mark is printed at the receiving end on the top of each page of the
fax messages that are forwarded from your machine. This mark will help the
operator at the other end to recognize messages that have been forwarded. If you
wish, you can switch this mark off.
To switch the Forwarding Mark on or off, do the following procedure. (See page 11
if you need more information about the User Parameter settings adjustment
procedure).
1. Function 6 2 2 2 2 6 and 3.
The settings for switch 00 are now
shown on the bottom line of the display.
If you want to forward all incoming mes-
sages from special terminals.
SWITCH8: 0100 0000
If you want to forward all incoming mes-
sages except those from special termi-
nals.
SWITCH8: 1100 0000
LINE TYPE (PSTN)
DP
or .
USER PARAMETER
DEFAULT: 01000000
SWITCH00: 01000000
RECEPTION
← →
SELECT
↑
TT
YES TO END ↓
PRINT LIST →
↑
YES TO END ↓
113