Ricoh fax4700l Operator's Manual page 269

APPENDIX E
Transmission Procedure
The following example shows how to dial (assuming that the ISDN Interface Type
140 has been installed). The differences between this procedure and the
procedure for the base machine (refer to page 24) are as follows:
You have to select G3 or G4 before you dial a number.
You may have to input a subaddress for a G4 number if the destination has one.
1. Make sure that the machine is in standby
mode (see page 24).
2. Carefully place the document into the auto
document feeder.
3. Change the line type (G3/G4) to the
correct setting by pressing the G4 key
on the operation panel.
4. Dial.
See page 26 for how to dial.
You may use Speed Dial, Quick
Dial, Group Dial, or the ten-key pad.
G3 numbers - If your machine is behind a PBX, include the PBX access code and a pause
before the number. For an international number, place a pause after the country code.
G4 numbers - If you wish to enter a subaddress, press the User Function Key that you have
already programmed as the subaddress key. Then enter the subaddress.
To enter a subaddress, you must use a User Function Key. See page 148 for how
to program a User Function Key using Function 36.
5. Yes.
6. Either:
Dial more numbers: go to step 4.
Start the transmission: Start.
Note: If the other party has not had a G4 Terminal ID programmed, you will see
" _ =" on the screen during transmission, instead of their ID.
258
MEMORY TRANS. APR.4.12:25PM
SET DOCUMENT OR ENTER FAX NO.
MEMORY TRANS.
ENTER FAX NUMBER
<G3>
MEMORY TRANS.
ENTER FAX NUMBER
<G4>
MEMORY TRANS.
PRESS YES OR CLR •
7005551234
_
MEMORY TRANS.
ENTER NO. OR START
_
MEMORY 100%
↓
OPTIONS
↓
OPTIONS
↓
OPTIONS
NO
↓
OPTIONS
DEST:2