Ricoh fax4700l Operator's Manual page 364

SENDING A FAX MESSAGE
Storing Double Sided Documents
When you are using Memory Transmission and press the User Function Key
programmed as Store Double Sided, both sides of a document can be scanned.
The front and back of the scanned document will be printed in order, on separate
sheets at the other end.
The procedure for transmission using Store Double Sided is outlined below
(for how to program the User Function Key, see page 143).
1. Check the Memory indicator is lit.
2. Press the User Function Key (F1-F5) programmed as Store Double Sided.
3. Set the double sided-document with the front page face down.
4. Select the resolution settings you require and dial then press Start. The front
page will start to be scanned. When scanning has finished, "TURN OVER,
RESET, PRESS START" will appear on the display.
5. Set the document with the reverse side face down and press Start. You have 60
seconds to set the reverse side --- if you do not, an error will occur and you
cannot transmit.
If "PAGE NO. INCORRECT CLEAR FILE? YES
pages have not been scanned in properly.
In this case, do one of the following:
Press Yes to completely erase the stored document and return to standby
mode.
Press No to return to standby mode and begin transmission of the pages
that have been stored so far.
Possible Problems
You want to take out the document
Open the scanner and take out the document.
CAUTION: Do not pull out the document without opening the scanner, or you
will damage the machine.
You want to send more than 50 pages
While the last page is being fed in, place more pages (up to 50) in the feeder.
You made a mistake while dialing
If you already pressed Start, press Stop immediately.
If you haven't pressed Start yet, do one of following:
Press No. The entire number is deleted. Enter a new number.
Press Clear. Only the last digit is deleted.
20
ROUTINE OPERATION
•
NO" appears on the display, your