Ricoh fax4700l Operator's Manual page 121

RECEPTION
Cross-references
RTI and CSI: see page 281.
Switching Authorized Reception On/Off
Before you use Authorized Reception, you have to switch it on using Function 62.
If it is switched off, the machine will accept any incoming fax message.
1. Function 6 0 2 2 2 2 6 and 2.
2. Scroll through the list of features with
until the screen is as shown opposite.
Press Yes.
3. Change the on/off setting by pressing
k
.
4. Finish: Yes and Function.
Programming the List of the Senders for Authorized Reception
A terminal sending an incoming message always identifies itself to your terminal.
The identification consists of an RTI, CSI or G4 TID code. When you specify the
senders for authorized reception, you must program a list of these codes.
1. Function 6 0 2 2 2 2 8 and 1.
DEST.6 on the opposite display shows
that there are 6 RTIs/CSIs/G4 TIDs
programmed so far. In a new machine,
you will see DEST.0.
At this time, you can print a Specified
Terminal List by pressing
2. Either:
Store some RTIs/CSIs/G4 TIDs: 1.
Go to step 3.
View the RTIs/CSIs/G4 TIDs that
you have stored so far: 2. Go to
step 6.
DEST.1/6 means that there are 6
RTIs/CSIs/G4 TIDs programmed
so far, and the first in the list is now
displayed.
Finish: Yes.
110
Wild Cards: see page 123.
PSTN LINE TYPE
m
AUTHORIZED RECEPTION SELECT ← →
j
or
AUTHORIZ. RX SELECT _
k
Start.
AUTHORIZ. RX
AUTHORIZ. RX
ADVANCED FEATURES
TCR: see page 176.
SELECT
DP TT
YES TO END ↓
ON OFF
YES TO END
PRINT LIST →
DEST. 6
1.RTI PROG 2.RTI NO TO CANCEL
ENTER RTI/CSI
NO TO CANCEL
_
NO TO CANCEL
DEST. 1/6
XYZ. CO.
← →
↑
↑
↓
A BC
CLR: CLR
↓