Specified Image Area (Function Upgrade Card Required) - Ricoh fax4700l Operator's Manual

Ricoh fax4700l:

Hide thumbs Also See for fax4700l:

Table of Contents

ADVANCED FEATURES

Specified Image Area (Function Upgrade Card Required)

If you only wish to transmit a part of the page, use this feature. You tell the

machine what area to scan by specifying two parameters: The Skip Length, and

the Scan Length. See the following diagram.

This feature cannot be used when you are transmitting using an OMR sheet,

immediate transmission, when you are making a copy.

Before you can to use the feature during a transmission, you must:

Set up the feature using Function 74 (see the next page).

Program one of the User Function Keys so that you can activate this feature

during the transmission procedure.

Note: If skip length is longer than the paper, the machine stops scanning.

When you send with Specified Image Area, Parallel Memory Transmis-

sion is cancelled and normal Memory Transmission takes place.

If Parallel Transmission is on, you cannot send just a few pages with

Specified Image Area. Should you want to send a few pages with Speci-

fied Image Area, turn Parallel Transmission off using function 63 (set

switch 07 digit 2 to "0").

Changing the Specified Image Area On/Off Home Position Setting

In a new machine, this setting is off. If you change this setting to "On", the image

area that you input (using Function 74 on the next page) will be used for all of

your transmitted pages, unless you switch off the light under the User Function

Key that you programmed for this feature.

1. Function 6 0 2 2 2 2 6 and 3.

TRANSMISSION

PRINT LIST →

USER PARAMETER

YES TO END ↓

Table of Contents