Choosing How To Treat The Programmed Senders - Ricoh fax4700l Operator's Manual

Choosing How to Treat the Programmed Senders

There are two ways to screen incoming messages for storage on Disk File:
Only save messages from terminals whose ID's have been programmed, or save
all messages exept those from terminals whose ID's have been programmed.
1. Function 6 0 2 2 2 2 6 and 3.
At this time, you can print a User
Parameter List if you press
2. The settings for switch 00 are now shown
on the bottom line of the display.
m
3. Press until the settings for switch 09 are
shown.
4. The setting that you need to change is
that for digit 2 (double underlined) and 3
(underlined).
Set one of the two as shown opposite.
5. To finish: Press Yes and Function.
List of Special
Terminals
(Function 81)
Empty/Not empty
Empty
Not empty
Not empty
k
and Start.
Reception to Memory
Disk On/Off
(Function 62)
Off
On
On
On
USER PARAMETER
DEFAULT: 01000000
SWITCH00: 01000000
USER PARAMETER
DEFAULT: 01000000
SWITCH09: 01000000
Only save messages from termi-
nals whose ID's have been pro-
grammed;
SWITCH09: 0000 0100
Save all messages, EXCEPT those from
terminals whose ID's have been pro-
grammed;
SWITCH09: 0000 1100
How to Treat the
Terminals (Function
63)
Either
Either
Listed
Non-listed
APPENDIX B
PRINT LIST →
↑
YES TO END ↓
PRINT LIST →
↑
YES TO END ↓
Result
No messages are
saved in the disk file.
All messages are
saved on the disk file.
Only messages from
Special Terminals are
saved on the disk file.
Messages from
Special Terminals
aren't saved in the
disk file, but all others
are.
237