Ricoh fax4700l Operator's Manual page 270

Storing a Telephone Number
The following example shows how to store a Quick Dial if the ISDN Interface Type
140 has been installed. The differences between this procedure and the
procedure for the base machine (refer to page 287) are as follows:
You have to select G3 or G4 before you input a Quick Dial or Speed Dial
You may have to input a subaddress for a G4 number if the destination has one.
1. Function 3 1.
2. Press the Quick Dial Key that you wish to
program.
Example: 01 Yes.
3. Change the line type (G3/G4) to the
correct setting by pressing the G4 key
on the operation panel.
4. Enter the telephone number at the
operation panel's ten key pad.
G3 numbers - If your machine is behind a PBX, include the PBX access code and a pause
before the number. For an international number, place a pause after the country code.
G4 numbers - If you wish to enter a subaddress, press the User Function Key that you have
already programmed as the subaddress key. Then enter the subaddress.
To enter a subaddress, you must use a User Function Key. See page 148 for how
to program a User Function Key using Function 36.
QUICK DIAL CHOOSE KEY
PRINT LIST →
n
_
NO TO CANCEL
QUICK DIAL ENTER FAX NUMBER
01 <G3> NO TO CANCEL
n
QUICK DIAL ENTER FAX NUMBER
01 <G4> NO TO CANCEL
n
QUICK DIAL YES OR CLR
01 <G4>
n
70 05 55 12 34
_
APPENDIX E
• NO
259