Using The Stamp - Ricoh fax4700l Operator's Manual

ROUTINE OPERATION

Using the Stamp

Press the Stamp key to achieve the transmission verification stamp.When the
Stamp indicator is lit, the machine stamps a small mark on the bottom of each
page. During memory transmission, the stamp indicates that the page was
successfully stored. For immediate transmission, it shows that the page was sent
successfully. You must switch the stamp on before you press Start , or the
machine will not stamp the first page.
If you wish the stamp to be at the top of each page instead of at the bottom,
contact your service representative.
Changing the Stamp Home Position Setting
If you wish to change the Stamp default setting, do the following.
(See page 11 if you need more information about the User Parameter settings
adjustment procedure).
1. Function 6 0 2 2 2 2 6 and 3.
At this time, you can print a User
Parameter List if you press
The settings for switch 00 are now shown
on the bottom line of the display. The
setting that you need to change is that
for digit 0.
2. If you wish to change the setting, press 0
on the ten key pad.
3. Finish: Yes and Function.
USER PARAMETER
DEFAULT:
and Start.
k
SWITCH00:
SWITCH00: 0000 0000
Digit 0 (Double Underlined)
0: Verification stamp off
1: Verification stamp on
SENDING A FAX MESSAGE
PRINT LIST →
↑
01000000
YES TO END ↓
01000000
43