Ricoh fax4700l Operator's Manual page 77

NETWORKING
Example Procedure (for Quick Reference)
Remote ID: 1111
Transfer Result Report Destination: Speed Dial 04 in your machine.
End Receivers, as programmed in your machine: Quick Dial 01, Speed Dial 02,
Group Dial 03.
1. The requesting party must dial your machine using an external telephone, and
wait for the fax tones.
2. When the fax tones come in, the requesting party must immediately input the
following sequence. (ACK: Wait for the ACK tone)
# - 1111# -
ACK
ACK
Your Machine's
Remote ID Code
3. When the requesting party hears fax tones again, they must press Start.
Notes
The remote ID code must have been programmed earlier.
After entering the ID code, if there is an interval of more than 5 seconds
followed by three short beeps repeated three times, enter the remote ID again.
If you enter the wrong remote ID, you will hear three short beeps. Try to enter
the code again. If you enter the wrong code five times, the remote control
services will not be available until you go back to the machine and reprogram
the ID (this is a security measure to prevent other people getting access to
your machine).
66
24# - *** - *04#
ACK ACK
Transfer Result
Report Destination:
Speed Dial 04
- 01# - *02#
ACK ACK
End Receiver:
Speed Dial 02
End Receiver:
Quick Dial 01
ADVANCED FEATURES
- **03# - ##
ACK
ACK ACK
End Receiver:
Group Dial 03
-
x3