Replacing The Chassis Feet - Thermo Scientific TSQ 9610 Hardware Manual

3
Advanced Troubleshooting
Replacing the Covers of the TSQ 9610 Instrument

Replacing the Chassis Feet

310 TSQ 9610 Hardware Manual
 To replace the chassis feet on the bottom of the TSQ 9610 instrument
Note See the ISQ and TSQ GC-MS Spare Parts Guide for information about ordering this
component.
1. Shut down your system by following the steps in
on page 139.
2. Remove the analyzer tray from the instrument by following the instructions in
"Removing the Analyzer Tray from the TSQ 9610 Instrument"
3. Follow the instructions in the section,
components required to safely replace the chassis feet.
4. Remove the small and large glass covers in the manifold.
5. Carefully tip the TSQ 9610 instrument and rest it on its left side.
6. Use a T20 Torxhead screwdriver to remove the screws holding any damaged feet to the
bottom of the instrument.
Figure 345. Removing the Feet on the Bottom of the TSQ 9610 Instrument
7. Attach the new chassis feet.
8. Set the instrument upright.
9. Replace the large and small glass manifold covers.
10. Follow the instructions in the section,
components you removed.
"Shutting Down the TSQ 9610 System"
"Distribution Board" on
Feet
"Distribution Board" on
on page 141.
page 350 to remove the
page 350 to replace the
Thermo Scientific