Power Module - Thermo Scientific TSQ 9610 Hardware Manual

Power Module

Thermo Scientific
 To replace the power module
Note See the ISQ and TSQ GC-MS Spare Parts Guide for information about ordering this
component.
1. Shut down your system by following the steps in
on page 139.
Note You do not have to remove the ion source cartridge or the column or vent the
instrument. If you are using hydrogen as a carrier gas, power off the GC.
2. Slide the top cover panel toward the back of the instrument and lift it off.
3. Disconnect the power cables from the side of the instrument.
3
Advanced Troubleshooting
Replacing the Power Supplies
"Shutting Down the TSQ 9610 System"
TSQ 9610 Hardware Manual 371