Thermo Scientific TSQ 9610 Hardware Manual page 385

Thermo Scientific
14. Look through the left side of the instrument and use a T20 Torxhead screwdriver to
loosen the screw holding the board to the chassis.
Tip The bracket has a white diagram describing the location of this screw. It is
approximately two inches from the top of the board directly under the white label.
Figure 393. Removing the Lens Driver Board
15. Loosening the screw will separate the board from the instrument. The screw is captured,
so do not attempt to completely remove the screw from the board and bracket.
16. Lift the lens driver board out of the instrument. Be careful as space is limited.
Note The steps to remove and replace the front and rear RF board/rod driver kits s are the
same. Refer to the images for the proper location of each board.
17. The front RF board is the second board standing on end toward the center of the
instrument. The rear RF board is the third board standing on end toward the center of
3
Advanced Troubleshooting
Replacing the Boards in the TSQ 9610 Instrument
Lens Driver Board Screw
TSQ 9610 Hardware Manual 355