Thermo Scientific TSQ 9610 Hardware Manual page 450

3
Advanced Troubleshooting
Replacing Fans and Filters
420 TSQ 9610 Hardware Manual
13. Disconnect the fan from the distribution board on the bottom of the instrument.
14. Lift the fan plenum and chassis cooling fan out of the instrument.
Figure 459. Removing the Fan Plenum and Chassis Cooling Fan
15. Disconnect the cable to the turbo cooling fan from the distribution board.
16. Remove the two corner M3 flat head screws from the turbo cooling fan and replace the
fan.
17. If you need to replace the turbo cooling fan filter, use a T10 Torxhead screwdriver to
remove the four screws holding the turbo cooling fan filter to the interior front panel.
18. Remove and replace the turbo cooling fan filter.
Thermo Scientific