Weinmann OXYWAY Fix I Service Manual page 93

Back Forward
14.9.2 Fitting the connecting bolt
1. Insert the connecting bolt 175 into the hand-screwed
connection 177.
2. Screw the hand-screwed connection 177 onto the bottom part of
the counter tool 400 by hand.
3. Tightly screw the hand-screwed connection 177 onto the top part
of the counter tool 400.
4. Insert the rib filter 154 into the connecting bolt 175.
5. Screw the housing onto the connecting bolt 175 by hand.
6. Push the counter cap 404 over the safety valve and the housing.
7. Place the torque wrench onto the square of the counter cap 404.
404
8. Use the torque wrench to tightly screw the housing onto the
175
connecting bolt 175.
When doing so, note: If using a new connecting bolt 175, it will
need to be loosened with the torque wrench and then re-tightened
again 3 times.
9. Remove the torque wrench and counter cap 404.
10.Loosen the hand-screwed connection 177 at the top part of the
counter tool 400.
11.Unscrew the hand-screwed connection 177 from the bottom part
of the counter tool 400 by hand and then remove.
12.Remove the hand-screwed connection 177 of the pressure reducer
from the counter tool 400.
13.Remove the top part of the counter tool 400 from the bottom part
of the counter tool 400.
14.Loosen the bottom part of the counter tool 400 from the vise and
remove.
15.Fit the O-ring 176 in the connecting bolt 175
(see "14.7.2 Fitting the O-ring in the connecting bolt", page
14.10 Replacing the hand-screwed
connection
14.10.1 Removing the hand-screwed connection
Requirement • The O-ring 176 has been removed from the connecting bolt 175
(see "14.7.1 Removing the O-ring from the connecting bolt",
page 90).
• The connecting bolt 175 has been removed
(see "14.9.1 Removing the connecting bolt", page
1. Dispose of the hand-screwed connection 177.
Contents
Repairs to OXYWAY Fast I, OXYWAY Fast I+, OXYWAY Fast III
Previous page
91).
92).
OXYWAY EN 93
Next page