Weinmann OXYWAY Fix I Service Manual page 198

Repairs to OXYWAY Fine I
198 EN OXYWAY
Back
16.24.2 Fitting the housing cover
1. Pick up the housing cover 264.
2. Fit the spindle 270
3. Fit the lifting pin with shoulder 265
4. Fit the spring for the lifting pin 263
5. Fit the piston 261
6. Fit the spring for the piston 262
7. Fit the assembly housing cover 275
8. Fit the driving plate 266
9. Fit the multistep flow selector 267
10.Fit the hexagon nut 268
11.Fit the cover for the multistep flow selector 269
12.Attach the label 274
16.25 Replacing the contents indicator
Required tools • Counter tool with fastening handle 400
• Watchmaker's screwdriver 409
• Vise
• Torque wrench 23 Nm ± 1 Nm
• Torque wrench 28 Nm ± 2 Nm
• Open-end wrench A/F 14
16.25.1 Removing the contents indicator
Requirements • The O-ring 272 has been removed from the connecting bolt 271
• The pressure gauge cap as protection against impact and falling has
1. Clamp the bottom part of the counter tool 400 in the vise.
2. Put the top part of the counter tool 400 onto the bottom part of
Forward
(see "16.23.2 Fitting the spindle", page
(see "16.22.2 Fitting the lifting pin with shoulder", page
(see "16.21.2 Fitting the spring for the lifting pin", page
(see "16.20.2 Fitting the piston", page
(see "16.19.2 Fitting the spring for the piston", page
(see "16.18.2 Fitting the assembly housing cover", page
(see "16.17.2 Fitting the driving plate", page
(see "16.16.2 Fitting the multistep flow selector", page
(see "16.15.2 Fitting the hexagon nut", page
(see "16.14.2 Fitting the cover for the multistep flow selector",
page 187).
(see "16.4.2 Attaching a label", page
(see "16.8.1 Removing the O-ring from the connecting bolt",
page 179).
been removed (see "16.7.1 Removing the pressure gauge cap as
protection against impact and falling", page
the counter tool 400.
Contents Previous page
196).
195).
194).
193).
192).
190).
189).
188).
188).
177).
179).
Next page