Weinmann OXYWAY Fix I Service Manual page 177

Back Forward
16.3 Assemblies
This chapter contains references to the assemblies defined in the
following table.
Assembly
Assembly housing cover 275
The assemblies are not available as complete units; only as individual
parts of the assemblies.
To remove parts other than those listed in the table, the assembly can
be removed as a complete unit.
16.4 Replacing a label
Required tools • Knife
• Spirit or Label remover
16.4.1 Removing a label
1. Remove the label 274 from the pressure reducer.
2. Use spirit or label remover to remove any residue from the pressure
274
reducer.
3. Dispose of the label 274.
16.4.2 Attaching a label
1. Pull the protective film off the back of the label 274.
When doing so, note: Do not touch the adhesive surface of the
label 274.
2. Stick the label 274 on the pressure reducer at the previously used
position.
274
When doing so, note: The adhesive surface must be free from dust
and grease.
Contents
Repairs to OXYWAY Fine I
Parts
• Housing cover
• Piston
• Spring for piston
• Spring for lifting pin
• Lifting pin with shoulder
• Spindle
OXYWAY
Previous page
EN 177
Next page