Weinmann OXYWAY Fix I Service Manual page 89

Back Forward
14.4.2 Attaching a label
1. Pull the protective film off the back of the label 178.
When doing so, note: Do not touch the adhesive surface of
the label 116.
2. Stick the label 178 on the pressure reducer at the previously used
position.
When doing so, note: The adhesive surface must be free from dust
178
and grease.
14.5 Replacing the pressure screw in the
inhalation outlet
Required tools Slot-head screwdriver
14.5.1 Removing the pressure screw from the
inhalation outlet
1. Use the slot-head screwdriver to loosen the pressure screw 156
in the inhalation outlet 155.
2. Remove the pressure screw 156 from the inhalation outlet 155.
155
156
14.5.2 Fitting the pressure screw in the inhalation
outlet
1. Insert the pressure screw 156 into the inhalation outlet 155.
When doing so, note: The slot on the pressure screw 156 must
be facing upwards when the screw is fitted.
2. Use the slot-head screwdriver to tightly screw in the pressure
155
screw 156 in the inhalation outlet 155.
156
Contents
Repairs to OXYWAY Fast I, OXYWAY Fast I+, OXYWAY Fast III
Previous page
OXYWAY EN 89
Next page