Weinmann OXYWAY Fix I Service Manual page 216

Repairs to OXYWAY Click
305
216 EN OXYWAY
Back
4. Align the slide disk 312 in your hand.
312
5. Use a brush to apply a thin coat of oxygen-compatible lubricant 414
6. Place the slide disk 312 on the holder for the orifice plate 313 and
312
314
313
7. Assemble the multistep flow selector assembly 323
8. Fit the multistep flow selector assembly 323
17.11 Replacing the threaded pin in the
multistep flow selector
Required tools Allen key size 2
17.11.1 Removing the threaded pin from the multistep
flow selector
Requirement • The multistep flow selector assembly 323 has been removed
• The multistep flow selector assembly 323 has been disassembled
1. Use the Allen key to remove the threaded pin 306 from the
306
Forward
When doing so, note: The side of the slide disk 312 that has
markings indicating another hole in addition to the hole for the
grooved pin must be facing upwards.
to the side of the slide disk 312 that is facing upwards.
the orifice plate 314.
When doing so, note: The grooved pin in the holder for the orifice
plate 313 must be inside the hole in the slide disk 312.
(see "17.9.2 Assembling the multistep flow selector assembly",
page 213).
(see "17.8.2 Fitting the multistep flow selector assembly",
page 211).
(see "17.8.1 Removing the multistep flow selector assembly",
page 211).
(see "17.9.1 Disassembling the multistep flow selector assembly",
page 212).
multistep flow selector 305.
Contents Previous page Next page