Transport/Start Up; Transport/Start Up; Transport, Storage, Shipping; Mounting - Leibinger JET2 neo Manual

Group 5

5. Transport/Start up

5.1 Transport, storage, shipping

In order to avoid damage during transport the following instructions must be observed.
The LEIBINGER JET2 neo must only be transported in a standing position. It is packed in
a cardboard box with special polystyrene inserts for safe dispatch during delivery.
Transport of the device must only be made in this packing in order to avoid damage.
The printer should be only transported in an empty condition! Two
special draining routines ("Main menu
Special functions
for the draining of the device.
You will find further information in the group Data/Programming in the
chapter Special functions under the point Drain routine (page 160)!
Note!
Storage temperatures below +5°C and above +50°C as well as storage at outside are
not admissible and can lead to damage!

5.2 Mounting

Caution – Danger of explosion!
The device should be only operated outside of explosive areas!
The installation has to be carried out according to the installation
instructions of the manufacturer!
Precautions regarding electrostatics have to be carried out!
Installation of the device
The device must be installed in a well ventilated room only and must be
kept away from any source of heat, flame or sparks, e.g. radiant
heater, etc.
Check device for damage! When determining a suitable place of setting up, the
necessary additional space requirement for the movement room of the operating and
service personnel must be taken into consideration. Solvents are processed in the
device, adequate room ventilation must be ensured!
JET2 neo

Transport/Start up

(Putting into service)
Deplete ink resp. Deplete solvent") are available
Service Hydraulic/Printhead
Release R1.07 en
Page 31