Counting Direction; End Value Controlloop/Stop After End Value; Counter Reset (Methods); Figure 170 Counter Settings (Reset Methods) - Leibinger JET3 up Operating Manual

Group 8

8.7.3.1.8 Counting direction

This setting controls the direction of the counting process.
 Counting direction forward: If this check box is activated the counter will be
incremented (+).
 Counting direction backwards: If this check box is activated, the counter will be
decremented (-).

8.7.3.1.9 End value controlLoop/Stop after end value

The setting controls the action of the counter by reaching the set end value.
 Stop at end value: If this check box is activated, no more counter is displayed
after the end value has been reached.
 Loop after end value: If this check box is activated the counting process and the
print will be started again from the beginning after the end value has been
reached.

8.7.3.1.10 Counter reset (methods)

With the Drop-down list <Counter Reset> you can define the reset method of the
counter.
Figure 170 Counter settings (Reset methods)
 manual: The reset happens manually by the operator in the dialog box
(Extra  Product Counter  Reset all Job Counters
 Product Counter: The reset of the job counter happens with the reset of the
production counter. This function is associated with the first product counter. A
second product counter would be ignored.
 extern signal: The reset happens by an external supplied signal (X4.1 on
interface X4. Please see appendix for details).
 Reset1 on X4: The reset happens by an external supplied signal on the X4
interface. The actual input has to be assigned in the I/O Settings dialog box (
Settings – I/O Settings – Inputs)
JET3up
Job Editor Page 323
Release R1.06