Table of Contents
Advertisement
Interfaces
See
Configure WAN/WWAN priority and default route metrics
metrics.
8. Save the configuration and apply the change:
(config network interface my_lan)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show LAN status and statistics
É
WebUI
1. Log into the Connect IT Mini WebUI as a user with Admin access.
2. From the menu, click Status.
3. Under Networking, click Interfaces.
Command line
1. Log into the Connect IT Mini command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the
show network
> show network
Interface
---------------- ----- ------- -------------------------------
defaultip
defaultlinklocal IPv4 up
eth
eth
loopback
modem
modem
>
3. Enter show network interface name at the Admin CLI prompt to display additional
information about a specific LAN. For example, to display information about ETH, enter show
network interface eth:
> show network interface eth
lan1 Interface Status
---------------------
Digi Connect IT® Mini User Guide
command at the Admin CLI prompt:
Proto Status Address
IPv4 up
192.168.210.1/24
169.254.100.100/16
IPv4 up
192.168.2.1/24
IPv6 up
fd00:2704::1/48
IPv4 up
127.0.0.1/8
IPv4 up
10.200.1.101/30
IPv6 down
Local Area Networks (LANs)
for further information about
104
Advertisement
Table of Contents
