Table of Contents
Advertisement
Firewall
viii. Set the source address type:
(config network qos 2 policy 0 rule 0)> src type value
(config network qos 2 policy 0 rule 0)>
where value is one of:
Digi Connect IT® Mini User Guide
any: Source traffic from any address will be matched.
n
See
Firewall configuration
interface: Only traffic from the selected interface will be matched. Set the
n
interface:
i. Use the ? to determine available interfaces:
(config network qos 2 policy 0 rule 0)>src interface ?
Interface: Match the IP address with the specified interface's network
address.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/lan
/network/interface/loopback
/network/interface/modem
Current value:
(config network qos 2 policy 0 rule 0)> src interface
ii. Set the interface. For example:
(config network qos 2 policy 0 rule 0)> src interface /network/interface/eth
(config network qos 2 policy 0 rule 0)>
address: Only traffic from the IP address typed in IPv4 address will be
n
matched. Set the address that will be matched:
(config network qos 2 policy 0 rule 0)> src address value
(config network qos 2 policy 0 rule 0)>
where value uses the format IPv4_address[/netmask], or any to match any
IPv4 address.
address6: Only traffic from the IP address typed in IPv6 address will be
n
matched. Set the address that will be matched:
(config network qos 2 policy 0 rule 0)> src address6 value
(config network qos 2 policy 0 rule 0)>
where value uses the format IPv6_address[/prefix_length], or any to match
any IPv6 address.
mac: Only traffic from the MAC address typed in MAC address will be matched.
n
Set the MAC address to be matched:
Configure Quality of Service options
for more information about firewall zones.
480
Advertisement
Table of Contents
