Digi Connect IT Mini User Manual page 53

Interfaces
To configure the Connect IT Mini device to reboot when an interface has failed:
É
WebUI
SureLink can be configured for both IPv4 and IPv6.
1. Log into the Connect IT Mini WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Create a new interface or select an existing one:
To create a new interface, see
n
or Configure a Wireless Wide Area Network
To edit an existing interface, click to expand the appropriate interface.
n
5. After creating or selecting the interface, click IPv4 (or IPv6) > SureLink.
6. Enable SureLink.
SureLink can be enabled for both IPv4 and IPv6 configurations. By default, SureLink is enabled
for IPv4 for the preconfigured WAN (ETH) and WWAN (Modem). It is disabled for IPv6.
7. Enable Reboot device.
Note If both the Restart interface and Reboot device parameters are enabled, the Reboot
device parameter takes precedence.
8. Click to expand Test targets.
9. For Add Test Target, click g .
10. Select the Test type:
Ping test: Tests connectivity by sending an ICMP echo request to the hostname or IP
n
address specified in Ping host. You can also optionally change the number of bytes in
the Ping payload size.
DNS test: Tests connectivity by sending a DNS query to the specified DNS server.
n
Digi Connect IT® Mini User Guide
Configure a LAN, Configure a Wide Area Network
(WWAN).
Wide Area Networks (WANs)
(WAN),
53