Table of Contents
Advertisement
Configuration and management
4. Enter a new password for the admin user. The password must be at least ten characters long
and must contain at least one uppercase letter, one lowercase letter, one number, and one
special character.
5. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect IT Mini command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set a new password for the admin user. The password must be at least ten characters long
and must contain at least one uppercase letter, one lowercase letter, one number, and one
special character.
(config)> auth user admin password new-password
(config)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configuration methods
There are two primary methods for configuring your Connect IT Mini device:
Digi Connect IT® Mini User Guide
Configuration methods
25
Advertisement
Table of Contents
