Digi Connect IT Mini User Manual page 332

Services
To limit access based on firewall zones:
n
(config)> add service ntp acl zone end value
Where value is a firewall zone defined on your device, or the any keyword.
Repeat this step to list additional firewall zones.
Note By default, the access control list for the NTP service is empty, which means that all
downstream hosts connected to the Connect IT Mini device can use the NTP service.
6. (Optional) Set the timezone for the location of your Connect IT Mini device. The default is UTC.
(config)> system time timezone value
(config)>
Where value is the timezone using the format specified with the following command:
(config)> system time timezone ?
Timezone: The timezone for the location of this device. This is used to adjust the time for log
messages. It also affects actions that occur at a specific time of day.
Format:
Africa/Abidjan
Africa/Accra
Africa/Addis_Ababa
...
(config)>
Digi Connect IT® Mini User Guide
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be referred to by
packet
filtering rules and access control lists.
Additional Configuration
-------------------------------------------------------------------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Configure the device as an NTP server
332