Digi Connect IT Mini User Manual page 501

System administration
3. In the Configuration Restore section:
a. If a passphrase was used to create the configuration backup, for Passphrase
(save/restore), enter the passphrase.
b. Under Configuration Restore, click Choose File.
c. Browse to the system firmware file location on your local computer and select the file.
d. Click RESTORE.
4. Click CONFIRM.
The configuration will be restored and the device will be rebooted.
Command line
1. Log into the Connect IT Mini command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. If the configuration backup is on a remote host, use scp to copy the file from the host to your
device:
> scp host hostname-or-ip user username remote remote-path local local-path to local
where:
hostname-or-ip is the hostname or ip address of the remote host.
n
username is the name of the user on the remote host.
n
remote-path is the path and filename of the file on the remote host that will be copied to
n
the Connect IT Mini device.
local-path is the location on the Connect IT Mini device where the copied file will be
n
placed.
For example:
> scp host 192.168.4.1 user admin remote /home/admin/bin/backup-archive-0040FF800120-
19.05.17-19.01.17.bin local /etc/config/ to local
3. Enter the following:
> system restore path [passphrase passphrase ]
where
Digi Connect IT® Mini User Guide
Configuration files
501