Table of Contents
Advertisement
System administration
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the following:
> system factory-erase
3. After resetting the device:
a. Connect to the Connect IT Mini by using the serial port or by using an Ethernet cable to
connect the Connect IT Mini ETH port to your PC.
b. Log into the Connect IT Mini:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
Note
If your device was manufactured prior to the release of firmware version 19.11.x, the
default user name may be root.
When you first log into the WebUI or the command line, you must change the password for
the admin user. See
c. Reset the default password for the admin account. See
the admin user
Reset the device by using the ERASE button.
1. Locate the ERASE button on your device.
2. Press and hold the ERASE button perform a device reset. The ERASE button has two modes:
Configuration reset:
n
Press and release the ERASE button.
l
The device reboots automatically and resets to factory defaults. This does not
l
remove any automatically generated certificates and keys.
Full device reset:
n
After the device reboots from the first button press, immediately press and release
l
the ERASE button again.
The device reboots again and resets to factory defaults, as well as also removing
l
generated certificates and keys.
3. After resetting the device:
a. Connect to the Connect IT Mini by using the serial port or by using an Ethernet cable to
connect the Connect IT Mini ETH port to your PC.
b. Log into the Connect IT Mini:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
Note
If your device was manufactured prior to the release of firmware version 19.11.x, the
default user name may be root.
Digi Connect IT® Mini User Guide
Change the default password for the admin user
for further information.
Reset the device to factory defaults
for instructions.
Change the default password for
496
Advertisement
Table of Contents
