Table of Contents
Advertisement
Routing
a. Use the ? to determine available interfaces:
b. Set the interface. For example:
address: Matches the source IPv4 address to the specified IP address or network. Set
n
the address that will be matched:
(config network route policy 0)> src address value
(config network route policy 0)>
where value uses the format IPv4_address[/netmask], or any to match any IPv4
address.
address6: Matches the source IPv6 address to the specified IP address or network. Set
n
the address that will be matched:
(config network route policy 0)> src address6 value
(config network route policy 0)>
where value uses the format IPv6_address[/prefix_length], or any to match any IPv6
address.
mac: Matches the source MAC address to the specified MAC address. Set the MAC
n
address to be matched:
(config network route policy 0)> src mac MAC_address
(config network route policy 0)>
10. Set the destination address type:
(config network route policy 0)> dst type value
(config network route policy 0)>
where value is one of:
zone: Matches the destination IP address to the selected firewall zone. Set the zone:
n
a. Use the ? to determine available zones:
Digi Connect IT® Mini User Guide
(config network route policy 0)>src interface ?
Interface: The network interface.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/lan
/network/interface/loopback
/network/interface/modem
Current value:
(config network route policy 0)> src interface
(config network route policy 0)> src interface /network/interface/eth
(config network route policy 0)>
(config network route policy 0)> dst zone ?
IP routing
149
Advertisement
Table of Contents
