The Revert Command - Digi Connect IT Mini User Manual

Hide thumbs Also See for Connect IT Mini:

Table of Contents

Command line interface

b. Use the show command to verify that the local authentication method was removed:

(config)> show auth method

Move elements within a list

Use the move command to reorder elements in a list.

For example, to reorder the authentication methods:

1. Use the show command to display current authentication method configuration:

(config)> show auth method

2. To configure the device to use TACACS+ authentication first to authenticate a user, use the

move index_number_1 index_number_2 command:

(config)> move auth method 1 0

3. Use the show command again to verify the change:

(config)> show auth method

The revert command

The revert command is used to revert changes to the Connect IT Mini device's configuration and

restore default configuration settings. The behavior of the revert command varies depending on

where in the configuration hierarchy the command is executed, and whether the optional path

parameter is used. After executing the revert command, you must save the configuration changes by

using the save command. You can also discard the configuration changes by using the cancel

CAUTION! The revert command reverts all changes to the default configuration, not only

unsaved changes.

Revert all configuration changes to default settings

To discard all configuration changes and revert to default settings, use the revert command at the

config prompt without the optional path parameter:

Digi Connect IT® Mini User Guide

Configuration mode