Digi Connect IT Mini User Manual page 554

Diagnostics
Timestamp
---------------- ------- --------- -------------------------------------------
Nov 26 21:42:37 status stat
Nov 26 21:42:35 status system local_time=Thu, 08 Aug 2019 21:42:35 +0000~uptime=3 hours,
0 minutes, 48 seconds
...
>
3. (Optional) Use the show event number num command to limit the number of lines that are
displayed. For example, to limit the event list to the most recent ten lines:
> show event number 10
Timestamp
---------------- ------- --------- -------------------------------------------
Nov 26 21:42:37 status stat
Nov 26 21:42:35 status system local_time=Thu, 08 Aug 2019 21:42:35 +0000~uptime=3 hours,
0 minutes, 48 seconds
...
>
4. (Optional) Use the show event table value command to limit the number of lines that are
displayed. Allowed values are error, info, and status. For example, to limit the event list to only
info messages:
> show event table info
Timestamp
---------------- ------- --------- -------------------------------------------
Nov 26 22:01:26 info user
Nov 26 22:01:25 info user
...
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Digi Connect IT® Mini User Guide
Type Category Message
intf=eth1~type=ethernet~rx=11332435~tx=5038762
Type Category Message
intf=eth1~type=ethernet~rx=11332435~tx=5038762
Type Category Message
name=admin~service=cli~state=opened~remote=192.168.1.2
name=admin~service=cli~state=closed~remote=192.168.1.2
View system event logs
554