Digi Connect IT Mini User Manual page 486

Hide thumbs Also See for Connect IT Mini:

Table of Contents

System administration

1. Log into the Connect IT Mini WebUI as a user with full Admin access rights.

2. On the menu, click System. Under Configuration, click Device Configuration.

The Configuration window is displayed.

3. Click System.

4. For Name, type a name for the device. This name will appear in log messages and at the

command prompt.

5. For Contact, type the name of a contact for the device.

6. For Location, type the location of the device.

7. For Banner, type a banner message that will be displayed when users log into terminal

services on the device.

8. Click Apply to save the configuration and apply the change.

Command line

1. Log into the Connect IT Mini command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. Set a name for the device. This name will appear in log messages and at the command prompt.

(config)> system name 192.168.3.1

192.168.3.1(config)>

4. Set the contact for the device:

192.168.3.1(config)> system contact "Jane User"

192.168.3.1(config)>

5. Set the location for the device:

192.168.3.1(config)> system location "9350 Excelsior Blvd., Suite 700, Hopkins, MN"

192.168.3.1(config)>

Digi Connect IT® Mini User Guide

Configure system information