Table of Contents
Advertisement
Interfaces
The preconfigured WAN is configured by default to use SureLink to both test the interface
status and perform a test DNS query.
Additional configuration items
The behavior of the Connect IT Mini device upon test failure:
n
The default behavior, which is to fail over to the next priority WAN/WWAN.
l
Restart the WAN interface.
l
Reboot the device.
l
The interval between connectivity tests.
n
The number of probe attempts before the WAN is considered to have failed.
n
The amount of time that the device should wait for a response to a probe attempt before
n
considering it to have failed.
If the type of probe test is:
n
Ping: Configure the number of bytes in the ping packet.
l
Interface status: Configure the amount of time that the interface is down before it is
l
considered to have failed, and the amount of time it takes to make an initial connection
before it is considered down.
Additional test targets.
n
If more than one test target is configured, determine whether the interface should fail over
n
based on the failure of one of the test targets, or all of the test targets.
To configure the Connect IT Mini device to regularly probe connections through the WAN:
É
WebUI
SureLink can be configured for both IPv4 and IPv6.
1. Log into the Connect IT Mini WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Create a new WAN or WWAN or select an existing one:
To create a new WAN or WWAN, see
n
a Wireless Wide Area Network
To edit an existing WAN or WWAN, click to expand the appropriate WAN or WWAN.
n
Digi Connect IT® Mini User Guide
Configure a Wide Area Network (WAN)
(WWAN).
Wide Area Networks (WANs)
or
Configure
46
Advertisement
Table of Contents
