Digi Connect IT Mini User Manual page 497

Hide thumbs Also See for Connect IT Mini:

Table of Contents

System administration

When you first log into the WebUI or the command line, you must change the password for

the admin user. See

c. Reset the default password for the admin account. See

the admin user

Reset the device with the revert command

You can reset the device to the default configuration without removing scripts, keys, and logfiles by

using the revert command:

1. Log into the Connect IT Mini command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. At the config prompt, enter revert:

(config)> revert

4. Set the password for the admin user prior to saving the changes:

(config)> auth user admin password pwd

5. Save the configuration and apply the change:

(config)> save

Configuration saved.

6. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Digi Connect IT® Mini User Guide

Change the default password for the admin user

for further information.

Reset the device to factory defaults

for instructions.

Change the default password for