Table of Contents
Advertisement
Services
Configure telnet access
By default, the telnet service is disabled.
Note
Telnet is an insecure protocol and should only be used for backward-compatibility reasons, and
only if the network connection is otherwise secured.
Required configuration items
Enable telnet access.
n
Configure access control for the telnet service.
n
Additional configuration items
Port to use for communications with the telnet service.
n
Multicast DNS (mDNS) support.
n
See
Set the idle timeout for Connect IT Mini users
for the telnet service.
Enable the telnet service
The telnet service is disabled by default. To enable the service:
É
WebUI
1. Log into the Connect IT Mini WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > telnet.
4. Click Enable.
5. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect IT Mini command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
Digi Connect IT® Mini User Guide
for information about setting the inactivity timeout
Configure telnet access
294
Advertisement
Table of Contents
