Table of Contents
Advertisement
Interfaces
b. IPv6 support is enabled by default. To disable:
(config network interface my_wwan)> ipv6 enable false
(config network interface my_wwan)>
c. Set the metric.
(config network interface my_wwan)> ipv6 metric num
(config network interface my_wwan)>
See
Configure WAN/WWAN priority and default route metrics
metrics.
d. Set the relative weight for default routes associated with this interface. For multiple active
interfaces with the same metric, the weight is used to load balance traffic to the
interfaces.
(config network interface my_wwan)> ipv6 weight num
(config network interface my_wwan)>
e. Set the management priority. This determines which interface will have priority for central
management activity. The interface with the highest number will be used.
(config network interface my_wwan)> ipv6 mgmt num
(config network interface my_wwan)>
f. Set the MTU.
(config network interface my_wwan)> ipv6 mtu num
(config network interface my_wwan)>
g. See
Configure SureLink active recovery to detect WAN/WWAN failures
about configuring active recovery.
2. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show WAN and WWAN status and statistics
É
WebUI
1. Log into the Connect IT Mini WebUI as a user with Admin access.
2. From the menu, click Status.
3. Under Networking, click Interfaces.
Digi Connect IT® Mini User Guide
Wide Area Networks (WANs)
for further information about
for information
92
Advertisement
Table of Contents
