Digi Connect IT Mini User Manual page 153

Hide thumbs Also See for Connect IT Mini:

Table of Contents

1. Log into the Connect IT Mini WebUI as a user with full Admin access rights.

2. On the menu, click System. Under Configuration, click Device Configuration.

The Configuration window is displayed.

3. Click Network > Routes > Routing services.

4. Click Enable.

The default firewall zone setting, Dynamic routes, is specifically designed to work with routing

services and should be left as the default.

5. Configure the routing services that will be used:

a. Click to expand a routing service.

b. Enable the routing service.

c. Complete the configuration of the routing service.

6. Click Apply to save the configuration and apply the change.

Command line

1. Log into the Connect IT Mini command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

Digi Connect IT® Mini User Guide