Table of Contents
Advertisement
Services
d. Click gagain to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
a. Click IPv6 Addresses.
b. For Add Address, click g .
c. For Address, enter the IPv6 address or network that can access the device's SSH
d. Click gagain to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the Connect IT Mini
n
device:
a. Click Interfaces.
b. For Add Interface, click g .
c. For Interface, select the appropriate interface from the dropdown.
d. Click gagain to allow access through additional interfaces.
To limit access based on firewall zones:
n
a. Click Zones.
b. For Add Zone, click g .
c. For Zone, select the appropriate firewall zone from the dropdown.
d. Click gagain to allow access through additional firewall zones.
6. Multicast DNS (mDNS) is enabled by default. mDNS is a protocol that resolves host names in
small networks that do not have a DNS server. To disable mDNS, or enable it if it has been
disabled, click Enable mDNS.
7. For Private key, type the private key in PEM format. If Private key is blank, the device will use
an automatically-generated key.
8. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect IT Mini command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
Digi Connect IT® Mini User Guide
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the SSH service.
l
service. Allowed values are:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the SSH service.
l
See
Firewall configuration
for information about firewall zones.
Configure SSH access
288
Advertisement
Table of Contents
