Show Lan Status And Statistics - Digi Connect IT 16 User Manual

Interfaces
5. Save the configuration and apply the change:
(config network interface LAN2)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Task four: Verify the new configuration
The final step in this example is to verify the new configuration.
1. Verify that LAN1 is operating correctly:
a. Connect a device to LAN1 through the ETH1 Ethernet port, or by connecting to the
Example_AP Wi-Fi1 access point.
b. Verify that the device has been provided an IP address from the LAN DHCP server in the
192.168.3.* subnet.
2. Verify that LAN2 is operating correctly:
a. Connect a device to LAN2 through the ETH2 Ethernet port.
b. Verify that the device has been provided an IP address from the LAN2 DHCP server in the
192.168.4.* subnet.

Show LAN status and statistics


WebUI
1. Log into the Connect IT 16/48 WebUI as a user with Admin access.
2. From the menu, click Status.
3. Under Networking, click Interfaces.

Command line
1. Log into the Connect IT 16/48 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show network
> show network
Interface
----------------
defaultip
defaultlinklocal
eth1
eth1
eth2
Digi Connect IT® 16/48 User Guide
command at the Admin CLI prompt:
Proto Status Address
----- ------- -------------------------------
IPv4 up 192.168.210.1/24
IPv4 up 169.254.100.100/16
IPv4 up 10.10.10.10/24
IPv6 up fe00:2404::240:f4ff:fe80:120/64
IPv4 up 192.168.2.1/24
Local Area Networks (LANs)
131