Table of Contents
Advertisement
Virtual Private Networks (VPN)
17. Click to expand Local endpoint.
a. For Type, select either:
n
n
b. Click to expand ID.
i. Select the ID type:
18. Click to expand Remote endpoint.
a. For Hostname, select either a hostname or IP address. If your device is not configured to
initiate the IPsec connection (see IKE >
keyword any, which means that the hostname is dynamic or unknown.
b. Click to expand ID.
i. Select the ID type:
Digi Connect IT® Mini User Guide
Default route: Uses the same network interface as the default route.
Interface: Select the Interface to be used as the local endpoint.
Auto: The ID will be automatically determined from the value of the tunnels
n
endpoints.
Raw: Enter an ID and have it passed unmodified to the underlying IPsec stack.
n
For Raw ID value, type the ID that will be passed.
Any: Any ID will be accepted.
n
IPv4: The ID will be interpreted as an IP address and sent as an ID_IPV4_ADDR
n
IKE identity.
For IPv4 ID value, type an IPv4 formatted ID. This can be a fully-qualified
domain name or an IPv4 address.
IPv6: The ID will be interpreted as an IP address and sent as an ID_IPV6_ADDR
n
IKE identity.
For IPv6 ID value, type an IPv6 formatted ID. This can be a fully-qualified
domain name or an IPv6 address.
RFC822/Email: The ID will be interpreted as an RFC822 (email address).
n
For RFC822 ID value, type the ID in internet email address format.
FQDN: The ID will be interpreted as FQDN (Fully Qualified Domain Name) and
n
sent as an ID_FQDN IKE identity.
For FQDN ID value, type the ID as an FQDN.
KeyID: The ID will be interpreted as a Key ID and sent as an ID_KEY_ID IKE
n
identity.
For KEYID ID value, type the key ID.
Auto: The ID will be automatically determined from the value of the tunnels
n
endpoints.
Raw: Enter an ID and have it passed unmodified to the underlying IPsec stack.
n
For Raw ID value, type the ID that will be passed.
Any: Any ID will be accepted.
n
IPv4: The ID will be interpreted as an IPv4 address and sent as an ID_IPV4_
n
ADDR IKE identity.
For IPv4 ID value, type an IPv4 formatted ID. This can be a fully-qualified
domain name or an IPv4 address.
Initiate
connection), you can also use the
IPsec
191
Advertisement
Table of Contents
