Table of Contents
Advertisement
Configure Remote Power
Management
Configure the Connect IT to connect to a power controller using a
serial port
You can configure the Connect IT to connect to a power controller from a serial port.
To use a serial port, you must configure a serial port on the Connect IT to communicate with a power
controller. You can then connect the power controller to the serial port on the Connect IT using a
serial cable.
1. Review the serial settings for your power controller. You will use this information to configure
the Connect IT.
2. Verify that your serial cable has the correct pinout. See
3.
Configure a serial port for Power
4.
Connect a power controller to the Connect IT serial
Configure a serial port for Power Management
You can configure the serial port on the Connect IT to communicate with the power controller.
This is the port to which you will connect the power controller to the Connect IT using a serial cable.
1.
Log in to the web
2. Click System > Serial Configuration.
3. Expand Port 1.
4. Select Enable.
5. From the Mode list box, select the Power Management option.
6. In the Label field, enter a descriptive name for the port.
7. Expand the Serial Settings section. The entries in the following fields must match the
information for the power controller. Refer to your power controller manual for the correct
entries: Baud rate, Data bits, Parity, Stop bits, and Flow control.
8. Click Apply.
Digi Connect IT® Mini User Guide
Configure the Connect IT to connect to a power controller using a serial
Management.
UI.
Serial connector
pinout.
port.
port
34
Advertisement
Table of Contents
