Digi Connect IT Mini User Manual page 87

Interfaces
e. Set the Management priority. This determines which interface will have priority for
central management activity. The interface with the highest number will be used.
f. Set the MTU.
g. See Configure SureLink active recovery to detect WAN/WWAN failures
about configuring Active recovery.
12. Optional IPv6 configuration items:
a. Click IPv6 to expand.
b. IPv6 support is Enabled by default. Click to disable.
c. Set the Metric.
See Configure WAN/WWAN priority and default route metrics
metrics.
d. For Weight, type the relative weight for default routes associated with this interface. For
multiple active interfaces with the same metric, Weight is used to load balance traffic to
the interfaces.
e. Set the Management priority. This determines which interface will have priority for
central management activity. The interface with the highest number will be used.
f. Set the MTU.
g. See Configure SureLink active recovery to detect WAN/WWAN failures
about configuring Active recovery.
2. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect IT Mini command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new WWAN or edit an existing one:
To create a new WWAN named my_wwan:
n
(config)> add network interface my_wwan
(config network interface my_wwan)>
To edit an existing WWAN named my_wwan, change to the my_wwan node in the
n
configuration schema:
Digi Connect IT® Mini User Guide
Wide Area Networks (WANs)
for information
for further information about
for information
87