Table of Contents
Advertisement
Firewall
ix. Set the destination address type:
(config network qos 2 policy 0 rule 0)> dst type value
(config network qos 2 policy 0 rule 0)>
where value is one of:
Digi Connect IT® Mini User Guide
(config network qos 2 policy 0 rule 0)> src mac MAC_address
(config network qos 2 policy 0 rule 0)>
any: Traffic destined for anywhere will be matched.
n
See
Firewall configuration
interface: Only traffic destined for the selected Interface will be matched. Set
n
the interface:
i. Use the ? to determine available interfaces:
(config network qos 2 policy 0 rule 0)>dst interface ?
Interface: Match the IP address with the specified interface's network
address.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/lan
/network/interface/loopback
/network/interface/modem
Current value:
(config network qos 2 policy 0 rule 0)> dst interface
ii. Set the interface. For example:
(config network qos 2 policy 0 rule 0)> dst interface /network/interface/eth
(config network qos 2 policy 0 rule 0)>
address: Only traffic destined for the IP address typed in IPv4 address will be
n
matched. Set the address that will be matched:
(config network qos 2 policy 0 rule 0)> src address value
(config network qos 2 policy 0 rule 0)>
where value uses the format IPv4_address[/netmask], or any to match any
IPv4 address.
address6: Only traffic destined for the IP address typed in IPv6 address will be
n
matched. Set the address that will be matched:
(config network qos 2 policy 0 rule 0)> src address6 value
(config network qos 2 policy 0 rule 0)>
where value uses the format IPv6_address[/prefix_length], or any to match
any IPv6 address.
Configure Quality of Service options
for more information about firewall zones.
481
Advertisement
Table of Contents
