Digi Connect IT Mini User Manual page 182

Routing
É
WebUI
1. Log into the Connect IT Mini WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Status > VRRP.
The Virtual Router Redundancy Protocol window is displayed.
Command line
1. Log into the Connect IT Mini command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type
> show vrrp
VRRP Status Proto State Virtual IP
---- ------ ----- ------ -------------
VRRP_test Up
VRRP_test Up
>
3. To display additional information about a specific VRRP instance, at the Admin CLI prompt, type
show vrrp name
> show vrrp name VRRP_test
VRRP_test VRRP Status
---------------------
Enabled
Status
Interface
IPv4
Digi Connect IT® Mini User Guide
show vrrp:
IPv4 Backup 10.10.10.1
IPv4 Backup 100.100.100.1
name:
: True
: Up
: lan
Virtual Router Redundancy Protocol (VRRP)
182