Digi Connect IT Mini User Manual page 50

Interfaces
test is considered to have failed.
(Optional) Set the amount of time that the interface can be down before this test is
l
considered to have failed:
where value is any number of weeks, days, hours, minutes, or seconds, and takes
the format number{w|d|h|m|s}.
For example, to set interface_down_time to ten minutes, enter either 10m or
600s:
The default is 60 seconds.
(Optional) Set the amount of time to wait for an initial connection to the interface
l
before this test is considered to have failed:
where value is any number of weeks, days, hours, minutes, or seconds, and takes
the format number{w|d|h|m|s}.
For example, to set interface_timeout to ten minutes, enter either 10m or 600s:
The default is 60 seconds.
(Optional) Repeat to add additional test targets.
7. Optional active recovery configuration parameters:
a. Move back two levels in the configuration by typing .. ..:
(config network interface my_wan ipv4 surelink target 0)> .. ..
(config network interface my_wan ipv4 surelink>
b. To configure the device to restart the interface when its connection is considered to have
failed:
(config network interface my_wan ipv4 surelink)> restart enable
(config network interface my_wan ipv4 surelink>
This is useful for interfaces that may regain connectivity after restarting, such as a cellular
modem.
c. To configure the device to reboot when the interface is considered to have failed:
(config network interface my_wan ipv4 surelink)> reboot enable
(config network interface my_wan ipv4 surelink>
Digi Connect IT® Mini User Guide
(config network interface my_wan ipv4 surelink target 0)> interface_down_time value
(config network interface my_wan ipv4 surelink target 0)>
(config network interface my_wan ipv4 surelink target 0)> interface_down_time 600s
(config network interface my_wan ipv4 surelink target 0)>
(config network interface my_wan ipv4 surelink target 0)> interface_timeout value
(config network interface my_wan ipv4 surelink target 0)>
(config network interface my_wan ipv4 surelink target 0)> interface_timeout 600s
(config network interface my_wan ipv4 surelink target 0)>
Wide Area Networks (WANs)
50