Table of Contents
Advertisement
Services
A single IP address or host name.
l
A network designation in CIDR notation, for example, 192.168.1.0/24.
l
any: No limit to IPv4 addresses that can access the telnet service.
l
Repeat this step to list additional IP addresses or networks.
To limit access to specified IPv6 addresses and networks:
n
(config)> add service telnet acl address6 end value
(config)>
Where value can be:
A single IP address or host name.
l
A network designation in CIDR notation, for example, 2001:db8::/48.
l
any: No limit to IPv6 addresses that can access the telnet service.
l
Repeat this step to list additional IP addresses or networks.
To limit access to hosts connected through a specified interface on the Connect IT Mini
n
device:
(config)> add service telnet acl interface end value
(config)>
Where value is an interface defined on your device.
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config)> add service telnet acl zone end value
Where value is a firewall zone defined on your device, or the any keyword.
Digi Connect IT® Mini User Guide
Display a list of available interfaces:
Use ... network interface ? to display interface information:
(config)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip
Default IP
defaultlinklocal
Default Link-local IP
eth
ETH
loopback
Loopback
modem
Modem
config)>
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
Configure telnet access
297
Advertisement
Table of Contents
