Table of Contents
Advertisement
Get started with Connect IT 4
Note
This is required if you want to automatically connect the Connect IT to Digi® Remote Manager.
For more information, see
Connect hardware and connect to a cellular network
n
Connect hardware and connect to site network using an Ethernet LAN
n
Connect hardware and connect to a cellular network
This section explains how to connect the Connect IT hardware and then connect to a cellular network,
using a CORE module.
Note
By default, the device uses a cellular network. As an alternative, you can also use an Ethernet
LAN connection. See
To connect the hardware and connect to the cellular network:
1. Insert a CORE module with an activated SIM card. See
2. Connect the power supply unit to the device.
3. Verify the cellular network signal strength indicator on the front of the 4 shows two or more
bars for proper operation. See
Connect hardware and connect to site network using an Ethernet
LAN
This section explains how to connect the Connect IT hardware and then connect to a site network,
using an Ethernet cable.
Prerequisites
CAT 5/6 Ethernet cable, which must be purchased separately.
n
To connect the hardware and connect to a site network:
1. Plug the power supply unit into an AC power outlet and connect the other end to the Power
plug on the 4.
2. Connect one end of an Ethernet cable to your site gateway.
3. Connect the other end of the Ethernet cable to the Ethernet LAN port on the 4.
Digi Connect IT® 4 User Guide
Configure Connect IT using Remote
Connect hardware and connect to site network using an Ethernet
Signal
strength.
Connect the hardware to a network
Manager.
LAN.
Cellular ONLY: Insert the CORE
module.
11
Advertisement
Table of Contents
