Example Performance Test Using Iperf3 - Digi Connect IT Mini User Manual

Hide thumbs Also See for Connect IT Mini:

Table of Contents

Repeat this step to list additional firewall zones.

6. Save the configuration and apply the change:

(config)> save

Configuration saved.

7. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Example performance test using Iperf3

On a remote host with Iperf3 installed, enter the following command:

$ iperf3 -c device_ip

where device_ip is the IP address of the Connect IT Mini device. For example:

$ iperf3 -c 192.168.2.1

Connecting to host 192.168.2.1, port 5201

[ 4] local 192.168.3.100 port 54934 connected to 192.168.1.1 port 5201

[ ID] Interval

[ 4] 0.00-1.00 sec 26.7 MBytes 224 Mbits/sec 8 2.68 MBytes

[ 4] 1.00-2.00 sec 28.4 MBytes 238 Mbits/sec 29 1.39 MBytes

[ 4] 2.00-3.00 sec 29.8 MBytes 250 Mbits/sec 0 1.46 MBytes

[ 4] 3.00-4.00 sec 31.2 MBytes 262 Mbits/sec 0 1.52 MBytes

[ 4] 4.00-5.00 sec 32.1 MBytes 269 Mbits/sec 0 1.56 MBytes

[ 4] 5.00-6.00 sec 32.5 MBytes 273 Mbits/sec 0 1.58 MBytes

[ 4] 6.00-7.00 sec 33.9 MBytes 284 Mbits/sec 0 1.60 MBytes

[ 4] 7.00-8.00 sec 33.7 MBytes 282 Mbits/sec 0 1.60 MBytes

[ 4] 8.00-9.00 sec 33.5 MBytes 281 Mbits/sec 0 1.60 MBytes

[ 4] 9.00-10.00 sec 33.2 MBytes 279 Mbits/sec 0 1.60 MBytes

- - - - - - - - - - - - - - - - - - - - - - - - -

[ ID] Interval

[ 4] 0.00-10.00 sec 315 MBytes 264 Mbits/sec 37

[ 4] 0.00-10.00 sec 313 MBytes 262 Mbits/sec

Digi Connect IT® Mini User Guide

dynamic_routes

Use the iPerf service