Digi Connect IT Mini User Manual page 59

Interfaces
Command line
1. Log into the Connect IT Mini command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Change to the WAN or WWAN's node in the configuration schema. For example, to disable
SureLink for the Modem interface:
(config)> network interface modem
(config network interface modem)>
4. Disable SureLink:
(config network interface modem> ipv4 surelink enable false
(config network interface modem)>
5. Save the configuration and apply the change:
(config network interface my_wwan ipv4 surelink)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Disable DNS lookup
Alternatively, you can disable DNS lookup or other internet activity for device that use a private APN
with no Internet access, or that have restricted wired WAN connections that do not allow DNS
resolution, while retaining the SureLink interface test. The SureLink interface test determines if the
interface has an IP address assigned to it, that the physical link is up, and that a route is present to
send traffic out of the network interface.
É
WebUI
1. Log into the Connect IT Mini WebUI as a user with full Admin access rights.
Digi Connect IT® Mini User Guide
Wide Area Networks (WANs)
59