Digi Connect IT Mini User Manual page 512

Hide thumbs Also See for Connect IT Mini:

Table of Contents

4. Click Enable intelliFlow.

5. For Zone, select the firewall zone. Internal clients that are being monitored by IntelliFlow

should be present on the specified zone.

6. Click Apply to save the configuration and apply the change.

Command line

1. Log into the Connect IT Mini command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. Enable IntelliFlow:

(config)> monitoring intelliflow enable true

4. Set the firewall zone. Internal clients that are being monitored by IntelliFlow should be present

on the specified zone:

a. Determine available zones:

(config)> monitoring intelliflow zone ?

Zone: The firewall zone which is assigned to the network interface(s) that

intelliFlow will see as internal clients. intelliFlow relies on an internal to

external relationship, where the internal clients are present on the zone specified.

dynamic_routes

Default value: internal

Current value: internal

Digi Connect IT® Mini User Guide